The ICMP source control message is received. The message that the ICMP destination cannot be reached is Response message is not received in the timeout time.

Press the Q key to stop the ping command. By pinging multicast address 224.0.0.1, you can obtain the information about all hosts in directly-connected network segment that support multicast transmission. The routing switch is to export the addresses of all response hosts. If the destination address is the broadcast address (255.255.255.255) or the multicast address, the ICMP request message is sent on all interfaces that support broadcast or multicast. The command supports that the destination address is the broadcast address or the multicast address. Management mode, global configuration mode and interface configuration mode Time for each message to wait for response Sets the length of ICMP data in the message. Message takes the IP address of the source-interface interface Sets the source IP address of the message or the IP address ofР”Вefault value: Main IP address of the message-sending You can use the РІР‚вЂњf option to decide the smallest MTU on Problems, one node in the network may be configured to a small Path and the routing switch will then return an ICMP error Path, the message will be dropped by the routing switch on the If the message required to be sent is larger than the MTU of the

Sets the DF digit (message is not segmented). After the ping command is run, an ICMP request message is sent to the destination host, and then the destination host returns an ICMP response message. It is used to test host accessibility and network connectivity. Chapter 2 Terminal Service Configuration CommandР”В¬ommands 4.1 Network Testing Tool Commands 4.1.1 ping.1.1 Configuring File Management Commands.

Snmp ping tool